Trane Heating System AH541 User Manual

®
Installing the Tracer MP581/AH541 or Tracer Summit  
BMTX BCU Operator-Display Door Upgrade  
Ordering numbers: 4020 1156, S3090-0443-62, 4020 1224, S3090-0483-62  
To add an operator display to a Tracer MP581 or  
Tracer AH541 controller or a BMTX model building  
control unit (BCU), remove the enclosure door, then  
install the new door with the operator display. Keep  
this document at or near the controller for access to  
calibration and cleaning instructions for the  
operator display.  
7. Secure the operator-display cable to the enclo-  
sure with a wire tie.  
Setting up the operator display  
This section shows how to calibrate the operator-  
display touch screen and how to adjust the  
brightness and contrast. To set up the operator  
display screens and security, see the Tracer MP580/  
581 Programmable Controller Programming guide  
(CNT-SVP01B-EN), the Tracer AH540/541  
Configurable Air-Handler Controller Setup and  
Operations guide (CNT-SVX05B-EN), or the Tracer  
Summit System Programming guide (BMTX-  
SVP01A-EN).  
Removing the door  
To remove the enclosure door:  
1. Open the door to a 90° angle from the enclosure  
2. Lift the door to pull the hinge pegs from the  
hinge holes.  
CAUTION  
Avoid Equipment Damage!  
Installing the door  
To clean the operator display, use a cloth dampened  
with commercial liquid glass cleaner. Spraying water  
or cleansers directly on the screen may result in  
equipment damage.  
To install the enclosure door:  
1. Unpack the door and check for missing or dam-  
aged parts. Check to make sure that the touch  
screen and magnetic latches are installed. Check  
for cracks in the plastic.  
Calibrating the operator display  
To calibrate the operator display:  
2. Hold the door at a 90° angle from the enclosure  
1. On the home screen, press the Setup button. The  
Setup menu appears.  
3. Align the hinge pegs on the door with the hinge  
holes on the enclosure.  
2. On the Tracer MP581 or Tracer AH541, press  
the page down button to view the next screen.  
4. Gently lower the door until it rests securely in  
the hinge holes.  
3. Press the Calibrate Touch Screen button. A cali-  
bration screen appears.  
5. Verify that the door swings freely on the hinges  
and that the magnetic latches hold the door  
securely when it is closed.  
CAUTION  
Avoid Equipment Damage!  
Do not allow the operator display to come in contact  
with sharp objects.  
6. Connect the operator-display cable to the opera-  
tor display and the main board (Figure 1 on  
page 2).  
4. Touch the target using a small, pliable, blunt  
object, such as a pencil eraser. Hold until the  
beeping stops. A second calibration screen  
appears.  
Note: The operator-display cable passes beneath  
the termination board on enclosures with  
factory-installed operator displays.  
Trane  
A Business of American Standard Companies  
© 2005 American Standard Inc All rights reserved.  
3270 3395 C  
 
Declaration of CE Conformity for the Tracer MP581 and Tracer  
AH541 operator displays  
Manufacturer name: Trane  
Manufacturer address: 4833 White Bear Parkway  
St. Paul MN 55110, USA  
The manufacturer hereby declares that the product:  
Product name: Tracer MP581 and Tracer AH541 operator displays  
Model numbers: 4020 1156  
Conforms to the following standards or other normative documents:  
Electromagnetic emission: EN50090-2-2:1996  
(by Council directive 89/336/EEC) Radiated EN55022:  
Conducted EN55022:  
1998 Class B limit  
1998 Class B limit  
Electromagnetic immunity: EN50090-2-2:1996  
(by Council directive 89/336/EEC) IEC 1000-4-2:1995  
EN61000-4-2  
6.0 kV by contact  
8.0 kV by air  
IEC 1000-4-3:1995  
EN61000-4-3:1996  
Amendment A1:1998  
10.0 V/m  
80 .. 1000 MHz  
IEC 1000-4-4:1995  
EN61000-4-4  
2.0 kV ac power lines  
1.0 kV signal lines  
IEC 1000-4-5:1995  
EN61000-4-5  
2.0 kV  
IEC 1000-4-6:1996  
EN61000-4-6  
10.0 V  
0.15 .. 80 MHz  
IEC 1000-4-8:1993  
EN61000-4-8  
IEC 1000-4-11:1994  
EN61000-4-
1
1  
When and Where Issued  
Electromagnetic Emission: 05/18/2001  
Electromagnetic Immunity: 05/18/2001  
John Olson  
Design/Compliance Engineer  
Mark of compliance  
European contact  
Societe Trane (Epinal, France)  
1, rue des Ameriques, B.P. 6  
F-88191 Golbey Cedex, France  
Phone: (33) 329.31.73.00  
Fax: (33) 329.81.24.98  
This document validates CE conformity of the Tracer MP581 and Tracer AH541 operator displays.  
3
3270 3395 C  
 
Declaration of CE Conformity for the Tracer Summit BMTX BCU  
operator display  
Manufacturer name: Trane  
Manufacturer address: 4833 White Bear Parkway  
St. Paul MN 55110, USA  
The manufacturer hereby declares that the product:  
Product name: Tracer Summit BMTX BCU operator display  
Model numbers: BMTX001BAA000, BMTX001BAA001,  
BMTX001BAA010, BMTX001BAA011  
Conforms to the following standards or other normative documents:  
Electromagnetic emission: EN61326-1  
(by Council directive 89/336/EEC) Radiated EN55022:  
Conducted EN55022:  
1998 Class B limit  
1998 Class B limit  
Electromagnetic immunity: EN61326-1  
(by Council directive 89/336/EEC)  
EN61000-4-2  
4.0 kV by contact  
8.0 kV by air  
EN61000-4-3:1996  
10.0 V/m  
Amendment A1:1998  
80 .. 1000 MHz  
EN61000-4-4  
2.0 kV ac power lines  
1.0 kV signal lines  
EN61000-4-5  
EN61000-4-6  
EN61000-4-8  
EN61000-4-11  
2.0 kV  
0.15 .. 80 MHz  
30 A/m  
1/2 cycle  
When and Where Issued  
Electromagnetic Emission: 4/5/2004  
Electromagnetic Immunity: 4/19/2004  
John Olson  
Design/Compliance Engineer  
Mark of compliance  
European contact  
Societe Trane (Epinal, France)  
1, rue des Ameriques, B.P. 6  
F-88191 Golbey Cedex, France  
Phone: (33) 329.31.73.00  
Fax: (33) 329.81.24.98  
This document validates CE conformity of the Tracer Summit BMTX BCU operator display.  
3270 3395 C  
4
 

Toastmaster Oven 389U User Manual
Toro Sprinkler TMC 424 User Manual
TP Link Network Router TD 8616B User Manual
Traulsen Freezer RET132EUT User Manual
Tricity Bendix Cooktop SE402 User Manual
Tripp Lite Computer Accessories NB1004BK User Manual
Troy Bilt Chipper CS4210 User Manual
Uniden Cordless Telephone WDECT3355 WDECT3355 User Manual
ViewSonic Flat Panel Television VS10725 User Manual
Viper Automobile Alarm 5101 User Manual